Frazer Rototiller Tillotson YC9A Carburetor Part # 5030

9+Internet Explorer Users - When you Add an item to Cart and want to continue shopping
Go ahead and close the second window and continue shopping with the original window.

ALL Parts are NEW unless marked Otherwise

Aeroshell 80 SAE 40 Oil for Gas Mixture - 1 NEW Quart $18.00
This product has been recommended by the Frazer Company

Mix 8 Ounces (1/2 pint or 1/4 Quart) Oil to 1 Gallon of Gasoline
Containers have Ounce Marks on Side
( Fuel Tank Capacity of Gas and Oil is 9 Quarts )
Thus 1 Quart should last for 4 Tank Loads of Gasoline

SNP Serial Number Plate (NEW) $10
I had sold the last of my New Old Stock which was made decades ago.
I found a vendor to make this new replica

HCP Hood Control Rod Plate (NEW) $35.00
I had a lot of people ask for this, so I finally found a vendor to make it.

5001 Complete Frazer Rototiller Engine for B1-6 thru B1-7

I have 20 Engines in "As is Condition", I have not done anything to the engine, all original parts
Includes everything on Page 2 of the Parts Book or Page 14 in Shop Manual
Which is everything forward of the Transmission

$125 each plus Shipping

5002 Engine Cylinder Block

For complete list of all Cylinder Block I have for sale click below

5003 Cylinder Block Stud $2.00

5004 Cylinder Block Gasket $4.95 (This is a different size and thickness than 5008)

5005 Aluminum Cylinder Head New $59.00 Used $29

5005 Steel Cylinder Head

USED $25.00

5006 Cylinder Head Stud $3.00
Choose Between
2-1/4" Long or 3-1/4" Long

5007 Cylinder Head Flat Washer $1.95
23/32" OD 25/64" ID

5008 Cylinder Head Gasket $4.95

5009 Used Crankshaft Assembly & Connecting Rod, Bearings $50.00

5009F Used Crankshaft Forward Half $25.00

5009R Used Crankshaft Rear Half $25.00

Check the OD of the Crank Pin you want
5010 Crankshaft Crankpin has 1.30" OD x 3.6" Long
5427 Crankshaft Crankpin has 1.06" OD and uses a Center Race with 1.30" OD

Shown below is 5010 for $20

5010A Crankshaft Pin with Set Screw Treaded Holes $20.00
Used - Refurbished

5011 Crankshaft Cap Screw $1.95

5012 USED From an old Frazer Rototiller Crankshaft Oil Seal Leather $7.50

5012 Crankshaft Oil Seal $19.95
Replaces JM-0137-20449 H1L5 which had replaced the original National 80055
(Can be used for either Front or Rear of the Crankshaft Assembly)

Put crank seal on with smooth side facing connecting rod, spring side facing rear and front
Put engine seal down even with the Insert Only, the seal will be 1/4" from Bearing at this position.

Redi Sleeve for 8012 $29.00 each
This is not required, but you want to make the 5012 not slip on the shaft and make the 5012 like the original National 80055 then use this speedie sleeve.

5013 NEW Crankshaft Bearing $18.00

front back

5013 USED Crankshaft Bearing (as is condition) $12.00

5014 USED Connecting Rod $10.00

5015 Set of 25 Needle Bearings for Lower Connecting Rod $5.00

5016 Set of 22 Needle Bearings for Upper Connecting Rod $4.00

5017 Connecting Rod Bearing Thrustwasher $2.95

5018 Connecting Rod Piston Pin Thrustwasher $2.95

USED 5019 Pistons $95.00 each
These have been cleaned, Bead Blasted and Cleaned Again

Rings (5022) are sold seperately

Choices are - Standard 3.000, Standard A (2.9925 to 2.9935), Standard B (2.0036 to 2.9945), Standard C (2.9946 to 2.9955), 3.010, 3.020, 3.030, 3.040, 3.070

5020 NEW Piston Pin $15.00

5020 Piston Pin USED - Good Condition $10.00

USED Slightly Worn (Outer Edges are 0.755" OD, Worn Middle is 0.754" OD) $5.00

5021 Piston Pin Lockring $1.50

5022-Sandard Piston Rings $99.00 for a set of 3
I sold out of my New Old Stock from 1950's
I had a company special make these.

5022-010 Piston Rings $99.00 for set of 3
I sold out of my New Old Stock from 1950's
I had a company special make these.

5022-020 Piston Rings $99.00 for a set of 3
I sold out of my New Old Stock from 1950's
I had a company special make these.

5022-030 Piston Rings $99.00 for a set of 3
I sold out of my New Old Stock from 1950's
I had a company special make these.

5022-040 Piston Rings $22.50 for a set of 3
These are New Old Stock (NOS) which this price was from 2003

5022-050 Piston Rings $22.50 for a set of 3
These are New Old Stock (NOS) which this price was from 2003

5022-060 Piston Rings $22.50 for a set of 3
These are New Old Stock (NOS) which this price was from 2003

I Do Not Have any 5022-070 Piston Rings

5023 Crankshaft 20 Teeth Helical Gear $9.95

2-1/16" ID Snap Ring $1.50

5027 NEW Intake & Exhaust Manifold
NEW $30.00

Used $15.00

5028 Intake & Exhaust Manifold Stud $4.95

5029 Intake & Exhaust Manifold Gasket $6.50

5030 Zenith 68 Series Carburetor $175.00
New Gaskets

5030 NEW Zenith 68J8 Series Carburetor    $350.00
This replaces the Tillotson YC9A
Comes with 5031 Gasket, Bolts and Split Washers

5030 Tillotson YC9A Carburetor - Rebuilt $120.00
Has been Cleaned in Heavy Duty Degreaser, Bead Blasted and Liquid Cleaned.
Float and Throttle and Idle Screws has been set to Shop Manual specs

All Carburetors Includes:
5031 Carburetor to Manifold Gasket                    5061 Body Gasket Installed
103 Bolt and 128 Spilt Washer 2 each
             ($2.95 value)                                                         ($4.95 value)


Add the convenience of a Petcock Drain by selecting 5035 Draincock down further on this page for for an additional $12.00.

NEW
5042 Choke Shaft Seal
5049 Float Needle
5067 Throttle Shaft Seal

5030 Carburetor Holley 859 is a Replacement for the Tillotson 5030
Missing the Throttle Assembly $50.00

5031 Carburetor to Manifold Gasket $4.95

5032 Used Original Carburetor Fuel Vapor Dispenser $10.00

5032 Carburetor Fuel Vapor Dispenser $4.95

5033 Carburetor Choke Control Cable $14.95

5035 Carburetor Bowl Drain Plug Crank $1.95
3/8-32 x 5/16" Your Choice of Head

Square Head Hex Head

Slotted Head Allen Head

Draincock Valve $12.00

Below is where it is mounted

5036 Carburetor Choke Valve $4.95

No Tab Tab Slot

5037 Carburetor Choke Valve Screw $1.95

5038 Carburetor Choke Valve Shaft $9.95

5038Z ZENITH Carburetor Choke Lever & Shaft $9.95

5038B Carburetor Choke Valve Shaft Lever $9.95

5039 Carburetor Choke & Throttle Valve Screw 6-32 x 3/8 Rd Hd $0.50
Used on 5039 Choke Lever Collar and 5063 Throttle Lever Collar

Fillister Zinc Head Round Brass Head