Tine
Spring Holder Removal Clamp
This is
for Tine Spring Holders that just won’t come off.
The
Removal Clamp consists of 2 Block Halves, 2 bolts and 2 nuts.
The Removal Clamp is drilled to accommodate a plate type puller or
can be used with a claw type puller.
The two
halves are bolted together between the last and next to last Tine Spring
Holder tabs.
The
fulcrum for your puller can be formed in one of two ways:
1.
A 3/8” X 24 tpi coupler nut (not
supplied) screwed onto the Tine Spring Holder stud.
Or
2.
A 3/8” Sch 40 length of
pipe. Cut to 6 ½” long for the
20-inch tilling width or 8 ½” long for the 26-inch tilling width (not
supplied).
Both of these items are readily available at your local
hardware store.
The
bolts and nuts for the plate type puller may be included with your puller or
readily available at your hardware store.